1st Shift Production Operator

Posted Date 3 months ago(1/8/2020 11:24 AM)
Job ID
# of Openings
Job Location: Address
1444 Alexander Road
ZIP Code


This position is for 1st Shift. 


Set-up, adjust, and operate several production machine tools where tooling, setup detail and operating procedures are standardized and obvious. Or, operate and maintain set-ups on special purpose machines where operations may involve several progressive machining sequences. Generally close tolerance work where dimensional and finish requirements are not difficult to maintain due to nature of tooling and machine setups. Work is usually repetitive and subject to in-process inspection. May be required to read part drawings and use adjustable, direct reading and fixed gauges to check work. Requires a fundamental knowledge of machine shop operations as acquired by short job training and experience. 


Adheres to all health, safety, and environmental policies and regulations.


Reads and follows all written job instructions and completes quality and inventory control inspections and documentation.


Selects and aligns tooling in machines according to specifications.


Positions work piece against fixtures or stops on machine.


Starts machine and observes operation to detect misalignment or malfunction.


Regulates air pressure and oil pressure.


Inspects work pieces for conformance to specifications and adjusts machine to correct errors.


Packages parts in appropriate containers.


Cleans and lubricates machines.



High school diploma or general education degree (GED). One to three months related experience and/or training is preferred.  Experience with air feed, roll feed, and secondary operations, and the ability to do safe, quick set-ups within the department is preferred.



Ability to read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals written in English.  Ability to write routing reports and correspondence in English.  Ability to speak effectively in English before groups.



Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals.  Ability to understand and convert to metric.  Ability to compute rate, ratio, and percent and to draw and interpret bar graphs.



Ability to apply commonsense understanding to carry out instructions furnished in written, oral, or diagram form. Ability to deal with problems involving several concrete variables in standardized situations.



Must be able to read blueprints. Should be familiar with inspection equipment such as vernier and micrometer.


PHYSICAL DEMANDS  The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.


While performing the duties of this job, the employee is regularly required to stand; use hands to finger, handle, or feel objects, tools, or controls; and reach with hands and arms. The employee frequently is required to walk. The employee is occasionally required to sit; stoop, kneel or crouch; and talk or hear.The employee must regularly lift and/or move up to 10 pounds, frequently lift and/or move up to 25 pounds, and occasionally lift and/or move more than 100 pounds. Specific vision abilities required by this job include the ability to adjust focus.


WORK ENVIRONMENT  The work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.


While performing the duties of this job, the employee regularly works near moving mechanical parts.  The noise level in the work environment is usually very loud.


Sorry the Share function is not working properly at this moment. Please refresh the page and try again later.
Share On Social Media